                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:1630652
CPU Delid tool 771/775/1150/1155/1156/1151 by Dawnaur is licensed under the Creative Commons - Attribution - Share Alike license.
http://creativecommons.org/licenses/by-sa/3.0/

# Summary

Needed parts:
- M8 bolt
- M8 nut
- 1 cent (euro cent)  coin.

Printing advises:
- 100% infill on both parts, at least on part 2.
- 200 microns is enough, but it is better to print in 100-150.
- working even with PLA
- you can use lubricant on the rail (such as lithium grease)

Compatibility:
All 37.5mm non-soldered intel LGA CPU are supposed to be compatible.
I can't test all CPU, but It worked so far on all generations from 775 to 1151, except 1156 that isn't tested (most of them, if not all were soldered).

Please note I am not responsible for eventual cpu destruction, or any other issue.
I share a functional and tested tool, you are responsible for what you do with.
And again, check if your cpu have internal paste or indium solder before trying to delid it !

If you have issues on sliding, be sure to remove any support trace, having your printer calibrated, and not printing too fast.


Upcoming:
A better version, permitting relid is in progress, I'll upload it when it is finished (early 2018)