-------- NVME SMART --------
0 Critical Warning				: 0
1 Composite Temperature				: 28
2 Available Spare				: 100
3 Available Spare Threshold			: 5
4 Percentage Used				: 0
5 Data Units Read				: 1736426
6 Data Units Written				: 2042560
7 Host Read Commands				: 43065315
8 Host Write Commands				: 47497575
9 Controller Busy Time				: 98
10 Power Cycles					: 102
11 Power On Hours				: 111
12 Unsafe Shutdowns				: 48
13 Media and Data Integrity Errors		: 0
14 Number of Error Information Log Entries	: 17
15 Warning Composite Temperature Time		: 0
16 Critical Composite Temperature Time		: 0
25 Thermal Management Temp 1 Transition Count	: 3
26 Thermal Management Temp 2 Transition Count	: 0
27 Total Time For Thermal Management Temp 1	: 219
28 Total Time For Thermal Management Temp 2	: 0
-------- Temperature --------
Max Temp All Time   : 112
Min Temp All Time   : 26
Max Temp Last Power : 53
Min Temp Last Power : 30
Temp Linkup         : 48
Temperature         : 28
Internal Temperature: 51
Flash temp. per die : 28 27 27 28 27 27 27 27 27 27 27 27 27 27 28 27
-------- SYSTEM STATUS LOG --------
disk init fail				: 0
disk hw status				: 0
write protect				: 0
ftl err path				: 0
hardware initial error			: 0
fw code update count			: 0
security state				: 33
gpio					: 0
power cycle count			: 0
abnormal power cycle count		: 48
fw internal power cycle count		: 0
power on time				: 399740(111h)
flash ip reset count			: 1
host e3d err count			: 0
flash e3d err count			: 0
ddr ecc err count			: 0
dbuf ecc err count			: 0
gc table trigger count			: 0
d1 gc data trigger count		: 0
d2 d3 gc data trigger count		: 33
dynamic d1 gc data trigger count	: 169
d1 gc block rate of data		: 100
d2 d3 gc block rate of data		: 100
dynamic d1 gc block rate of data	: 100
vendor aes set key status		: 0
axi err slave				: 0
axi err zone				: 0
d1 wear leveling check count		: 64
d1 wear leveling trigger count		: 128
d1 wear leveling block rate		: 100
d2 d3 wear leveling check count		: 32
d2 d3 wear leveling trigger count	: 64
d2 d3 wear leveling block rate		: 100
vuc protect mode			: 2
vuc protect state			: 3
-------- FLASH STATUS LOG --------
max erase count d1			: 0
max erase count d2 d3			: 12
average erase count d1			: 0
average erase count d2 d3		: 5
min erase count d1			: 0
min erase count d2 d3			: 1
total flash erase count d1		: 1029
total flash erase count d2 d3		: 1380
total flash program count d1		: 0
total flash program count d2 d3		: 189435932
total flash read count			: 2004076693
total flash write count			: 6061949824
read flash unc retry ok count d1	: 0
read flash unc retry ok count d2 d3	: 2030
read flash unc retry fail count d1	: 0
read flash unc retry fail count d2 d3	: 0
raid ecc recovery ok count d1		: 0
raid ecc recovery ok count d2 d3	: 0
raid ecc recovery fail count d1		: 0
raid ecc recovery fail count d2 d3	: 0
logical good block count d1		: 0
logical good block count d2 d3		: 229
total early bad physical block count	: 215
total later bad physical block count	: 0
total read fail block count d1		: 0
total read fail block count d2 d3	: 0
total program fail block count d1	: 0
total program fail block count d2 d3	: 0
total erase fail block count d1		: 0
total erase fail block count d2 d3	: 0
raid ecc entry				: 0
read disturb count			: 0
flash max pecycle			: 2000
revoked vb number			: 21
acceptable revoked vb number		: 21
-------- DRIVE INFO --------
maximum pca value			: 250051158
vuc buffer base				: 1196859392
vuc buffer size				: 131072
host read count				: 3556200433
host write count			: 4183161212
background read count			: 0
