A problem has been detected and Windows has been shut down to prevent damage
to your computer.

The problem seems to be caused by the following file: volsnap.sys



If this is the first time you've seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:

Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software manufacturer
for any Windows updates you might need.

If problems continue, disable or remove any newly installed hardware
or software. Disable BIOS memory options such as caching or shadowing.
If you need to use safe mode to remove or disable components, restart
your computer, press F8 to select Advanced Startup Options, and then
select Safe Mode.

Technical Information:

*** STOP: 0x00000133 (0x0000000000000001, 0x0000000000001e00, 0x0000000000000000,
0x0000000000000000)

*** volsnap.sys - Address 0xfffff88002fea180 base at 0xfffff88001f3d000 DateStamp
0x5010abc2

*** STOP: 0x00000101 (0x0000000000000019, 0x0000000000000000, 0xfffff8800356d180,
0x0000000000000007)

Dear customer:

Thanks for contacting ASROCK.

 

BSOD usually relate to the compatibility of memory.

Please follow the procedure to check your system.

1. Remove power cord and use jumper to clear CMOS.

(Refer user manual http://www.asrock.com/mb/Intel/Z68%20Extreme4/?cat=Manual)

2. then re-install CPU and memory modules.

3. Install only one memory module, and the CPU for try.(Remove all devices)

4. Install  memory module in different slot for try.

5. If possible, please try with another CPU and memory module for verify.

Thanks!

 

All the best,

ASRock TSD