Монитор | LG IPS226 FHD
Корпус | Aerocool Strike-X One
Материнская плата| Sabertooth 990fx R1
Процессор | AMD FX 8320 разгон 4.5 NB 2600 v1.45 93Gflp
Видео Карта | MSI GeForce GTX 780 Ti| разгон: Ядро 1006|Память 1825|boost 1230
Оперативная память | DDRIII Hynix 1333 9-9-9-9 : разгон до 2133 11-13-12-28 1,7v
Накопители | SSD KINGSTON SV300S3+Seagate 2x500gb в Raid 0+Seagate 1x1tb
Реобас | Zalman ZM-MFC1 Plus Black
Блок питания | Rosewill Lightning 1300
Термоинтерфейс | Arctic MX4+Coollaboratory Liquid Pro

Радиатор - Coolgate Copper Dual 120/60mm - в резерве
Радиатор - Alphacool NexXxoS UT60 Full 360\60mm
Радиатор - Phobya G-Changer 360/60 V.2
Резервуар - XSPC Single 5.25" Bay Reservoir (Alu Front)
Помпа - Syscooling sc-750
GPU - EK-FC Titan - Nickel|EK-FC Titan Backplate - Black
CPU - Alphacool NexXxoS XP³ Light - Acetal
Жидкость - на 1 литр дистилята, 300-400мл антифриза.
Шланги 10/13 G1\4

Originally Posted by The Stilt
the difference was smaller on this FX-9370 than I´ve measured on some of the FX-9590 samples.

Did a quick test without any charts or fancy, just to see if I have gone crazy and started to spread fud rolleyessmileyanim.gif

FX-9370 (P0 / Pb0 VID = 1.5125V)
Clocks and voltage used = 4600MHz (23x200), 1.375V (-0.1375V offset, -75% RLL), default NB & HT

FX-8370E (P0 VID = 1.1500V)
Clocks and voltage used = 4600MHz (23x200), 1.375V (+0.225V offset, -75% RLL), default NB & HT

Test (same for both, obviously) = Prime95 28.7 (Custom: 768K - 896K, 10 minutes).

All of the readings were measured at ~10 minute mark.

FX-9370

DCR Imax = 138.25A
DCR Vdd (Imax capture point) = 1.369V
DCR Pmax (calculated) = 189.26425W
VRMIn Hall Imax (over EPS12V) = 20.11A
VRMIn Vdd (Imax capture point) = 12.09V
VRMIn Pmax (calculated) = 243.1299W
VDDCR Measured (under load): 1.381V

FX-8370E

DCR Imax = 122.75A
DCR Vdd (Imax capture point) = 1.369V
DCR Pmax (calculated) = 168.04475W
VRMIn Hall Imax (over EPS12V) = 17.57A
VRMIn Vdd (Imax capture point) = 12.10V
VRMIn Pmax (calculated) = 212.597W
VDDCR Measured (under load): 1.383V

The DCR readings include power (current) drawn by the CPU cores and nothing else. The reading were observed on ASUS C5F-Z board, by using the RC Diagram program (accesses CHL8328 controller directly). The Hall (clamp over conductor) measures the input power (current) fed to the VRM and that reading includes NB power consumption (< 10W) and VRM losses too.

So even with the 5% ahead I promised, I would have won by 7.62%