# EXPERIMENTAL: This Setting makes the checksum calculate to
# the same value it originally was by manipulating an unused
# section of the bois. This may be needed for the new style
# UEFI vbios. Set this to 1 if you want to preserve the orig
# checksum. Set to 0 for the previous behavior of re-calculating
# the checksum. NOTE: if you're not having driver detection
# problems leave this at 0.
#
Preserve_Original_Checksum = 0


# Fan settings
Fan_Min = 30
Fan_Max = 100


# Board power settings
Max_Power_Target = 150


# Max Boost Frequency. Uncomment this if you want to change the
# maximum frequency your card will boost to.
#Max_Boost_Freq = 1228


# WARNNING:
# The following are valid voltages. I suggest you
# use these values rather than coming up with your
# own. 1212500 is the max and it is normally hard limited.
# If you go over the max and your board is hard limited
# you may actually get a much lower voltage than you
# expect.
#
Voltage = 1212500
# Voltage = 1200000
# Voltage = 1187500
# Voltage = 1175000
# Voltage = 1162500
# Voltage = 1150000