PROCHOT# - вход/выход с открытым стоком.

Это только выход, которые информирует остальные устройства,

А если замкнуть перемычкой с другим контактом но THERMTRIP# при этом не изолировать

Я почти уверен что это никто непроверял, теоретически этот сигнал может браться с линии активирующей внутренний тротлинг

Исключительно теоретически об механизме работы THERMTRIP# написано в документации

Там приводится два абзаца в разных местах, которые достаточно доходчиво поясняют принцип работы THERMTRIP#

THERMTRIP#
the processor will automatically shut down when the silicon temperature has reached its operating limit. at this point the system bus signal THERMTRIP# goes active and power must be removed from the processor. the temperature where the THERMTRIP# signal goes active is individually calibrated during manufacturing. once configured, the temperature at which the THERMTRIP# signal is asserted is neither re-configurable nor accessible to the system.

Open Drain Output - ...., THERMTRIP#, ....

Table 26
THERMTRIP# -- Output
In the event of a catastrophic cooling failure, the processor will automatically shut down when the silicon has reached a temperature approximately 20 °C above the maximum TC. Assertion of THERMTRIP# (Thermal Trip) indicates the processor junction temperature has reached a level beyond where permanent silicon damage may occur. Upon assertion of THERMTRIP#, the processor will shut off its internal clocks (thus, halting program execution) in an attempt to reduce the processor junction temperature. To protect the processor, its core voltage (VCC) must be removed following the assertion of THERMTRIP#. Driving of the THERMTRIP# signal is enabled within 10 μs of the assertion of PWRGOOD (provided VTT and VCC are valid) and is disabled on deassertion of PWRGOOD (if VTT or VCC are not valid, THERMTRIP# may also be disabled). Once activated, THERMTRIP# remains latched until PWRGOOD, VTT, or VCC is de-asserted. While the deassertion of the PWRGOOD, VTT, or VCC will de-assert THERMTRIP#, if the processor’s junction temperature remains at or above the trip level, THERMTRIP# will again be asserted within 10 μs of the assertion of PWRGOOD (provided VTT and VCC are valid).

Regardless of whether or not Thermal Monitor or Thermal Monitor 2 is enabled, in the event of a catastrophic cooling failure, the processor will automatically shut down when the silicon has reached an elevated temperature (refer to the THERMTRIP# definition in Table 26). At this point, the FSB signal THERMTRIP# will go active and stay active as described in Table 26. THERMTRIP# activation is independent of processor activity and does not generate any bus cycles.

И кувалдой его, кувалдой .

внутренний мониторинг и термозащита неотключаемы

maco мне почемуто кажется что еслиб нельзя было, вы бы в этой теме не постили

наверно буду сегодня снимать крышку теплораспределителя и смотреть, что с термоинтерфейсом !